By the end of this chapter you will be able to:

• Use the attribute function replaceAll()
• Use the attribute function toUpper()
• Use the attribute function substring()
• Use the attribute function if()
• Use the internal variable _out

Reformat post codes to remove all spaces and make upper case

In your Introduction to Modelling analysis model, you will now reformat post codes to remove all spaces, and ensure that all letters are upper case:

1. In your model, add a new table:
   1. Hover over Customer Details with Region, and press 

      Insert excerpt
      _table_new _table_new nopanel true

      .
   2. Give the new table the Name: Reformatted Customer Details.
   3. Drag all attributes from  to the new table Customer Details with Region.
2. Open the settings for the Reformatted Customer Details table.
   
   1. In the Attributes section, add a new attribute:
      • Press 

        Insert excerpt
        _add _add nopanel true

      • In the New Table Attribute settings, set:
        • Name: ReformattedPostCode
        • Leave the settings for the attribute as default (Type is String, Length is 50)
        • Expression:

toUpper(replaceAll(in.PostCode, " ", ""))

• • Press 

    Insert excerpt
    _finish _finish nopanel true

     on the New Table Attribute settings.

Generate short code for Counties

Now you will generate a short code for counties by taking the first 3 letters of the county for each customer detail record:

1. In the Reformatted Customer Details table settings, add a new attribute called CountyShortCode.
2. Leave the default settings.

3. Set the attribute's Expression to:

   Code Block
   substring(in.County, 1, 3)

   
   

4. Press 

   Insert excerpt
   _finish _finish nopanel true

   .

Categorise bills as "LARGE" or "NORMAL"

To categorise bills as "LARGE" or "NORMAL":

1. In the Reformatted Customer Details table settings, add a new attribute called BillCategory
2. Leave the default settings.

3. Set the attribute's Expression to:

   Code Block
   if (in.BILLAMOUNT > 10.0, "LARGE", "NORMAL")

   
   

4. Press 

   Insert excerpt
   _finish _finish nopanel true

   .

Set special processing flag _out

Finally, you will now set a special processing flag. This will be set to "YES" when the last bill for the customer is large. To do this, we need to access an attribute value that is in the table, but not in any of the input pipes to the table, only the table output.

To do this, you will use the internal variable _out:

1. In the Reformatted Customer Details table settings, add a new attribute called SpecialProcessing
2. Leave the default settings.

3. Set the attribute's Expression to:

   Code Block
   if (_out.BillCategory == "LARGE", "YES", "NO")

   
   

4. Press 

   Insert excerpt
   _finish _finish nopanel true

   .

Check Point - Table Attributes

1. The Attributes section for the Reformatted Customer Details table should now look like this:
   1. 

Run table

1. In the settings for the table Reformatted Customer Details, press 

   Insert excerpt
   _finish _finish nopanel true

   .
2. Run analysis on the table Reformatted Customer Details.
3. Have a look at the data in this table – check that all your transformations have been correctly applied, like the image below:
4. 
5. Remember to save your model layout, 

   Insert excerpt
   _save_saveModel _save_saveModel nopanel true

   .