...
Info |
---|
Unix/ Linux installation: these instructions guide you to setting up tomcat to run as a service under the classic init mechanism on unix/ linux (System V) since this will be available on all platforms, but you should consider using Upstart, a more modern init mechanism that will be available on most modern unix/ linux distributions. Installation using upstart is widely covered on the web. Further, at some versions of tomcat, on certain unix/ linux versions, a complete tomcat installation can be performed using a few simple package commands. Before you begin, a web search for tomcat installation at the desired version of tomcat, on the installed version of your unix/ linux distribution, may give you a much simpler installation method. However you install tomcat, please note the settings that are needed under configuring tomcat |
Download
The System Administrator should have set up a linked directory structure like [c:]/opt/tomcat. The details of this may differ between installations so from this point on, the “root” tomcat directory will be referred to as $TOMCAT.
...
- Use the required port number (port="8080"). Tomcat defaults to port 8080 for HTTP, but you may need to use a different port if you are running other web servers on the same host.
- Enable compression (compression="forceon"). Compressing responses from the server is particularly important if you are going to access the PhixFlow server over a slow connection (e.g. a mobile data connection).
...
Code Block | ||
---|---|---|
| ||
<!-- Define a non-SSL HTTP/1.1 Connector on port 8080 --> <Connector port="8080" protocol="HTTP/1.1" connectionTimeout="20000" redirectPort="8443" compression="forceon"/> |
Remember to enable this port in the server’s firewall (if enabled).
...